Day One Flooring logo

Quality Flooring in Los Angeles

Just like other fields, when dealing with a flooring contractor there are few thing to consider. It can be anything from removing carpet, refinishing wood floors, or installing marble tiles. It is always best to know what you are about to pay for, and hire the best contractors for the job. Day One Flooring will consider the project in its entirety and still beat all competitors.

Knowing the right flooring contractor to hire for your home or for your business can be a challenging and confusing task, that can affect your life in many aspects. You do not want to find in the next rain that he did not do a good job.

In this article you will find helpful tips to assist you in choosing the right flooring contractor and getting the best service for your money. Keep in mind that the information provided here can never replace the opinion of a qualified floor specialist who know homes in Los Angeles, who come to your place and who inspected the project from close.

flooring specialists Los Angeles

Measure

Determine the width and length of the room and multiply for the square footage. When ordering hardwood flooring, allow 10-15 percent extra for irregular boards and any cutting mistake.

Squeaky Floors

Check the sub-floor. Minimum requirements are a 3/4" plywood sub-floor. Make sure there are no screeches in the floor. If there's a squeak, screw a long drywall screw into the sub-floor and joist where the squeak occurs. Remove shoe-molding from the room and sweep and clean thoroughly.

Vapor Barrier Paper

Roll out strips of vapor barrier paper, allowing at least a 4" overlap and staple securely to the sub-floor. Use 15 pound tar paper or felt. It is relatively inexpensive (it's approximately $12 a roll at a home improvement store). Mark with a pencil along the baseboards where the joists are located.

Start Installation

Start the installation at the longest unobstructed wall. Remove the shoe molding, and snap a chalk line 3/8" out from the baseboard (this allows for expansion in the hot, humid weather and contraction in the colder, drier weather of the hardwood flooring).

Place the Boards

Begin by selecting a long board to start the first row. Pick one that is straight. Align the edge of the board with the chalk line and drill pilot holes down through the hardwood plank and into the sub-floor and joist. Face-nail each board at the point of every joist and set the nail with a nail-set. Face-nail the entire first row and remember to keep the board lengths random. It is important to face-nail the first row because the pneumatic nail can't get down in there. It will hit the wall and the force would push the wood against the baseboard, which would lose the 3/8" expansion and contraction.

It is important to lay the first boards perpendicular to the joists which are underneath. That is important because you want a nice solid anchor. Look at the subfloor to see which way the nails and seams ran. Try to go underneath the crawl space to see how they run.

Hand Nail Rolls

After the first few rows have been installed, drill pilot holes down into the tongue of each board and hand-nail the rolls until there is enough clearance for the pneumatic nail gun.

Tip: Lay out a box of hardwood boards ahead of the installation to visualize lengths, wood grain and colors of the boards. When laying out the boards, keep in mind to never have the ends of boards in adjacent rows line up with each other. Keep the lengths random and at least 6" in length.